CZMK 2,0-13,0mm Fixture with Morse taper shank Mk4

Katalogový list pro upínač CZMK

CZMK fixture can be used not only for clamping of the twist drills with straight shank, but also of other tools, such as centre and stepped drills, core drills, countersinks and wood drills. CZMK fixture has very small dimensions thanks to the original design with spring collet inserted directly into Morse taper cavity which enables to use it even on the place where only drills with Morse taper shank have been used so far.

The advantages of CZMK fixture in comparison with the drill with Morse taper shank:
- Very high variability of fixture usage because you can assemble the drill with Morse taper shank by means of CZMK fixture according to your own requirements because the assortment of the twist drills is beyond comparison bigger than the drills with Morse taper shank. Thus you can assemble the drills with Morse taper shank not only with different diameters, lengths, bit geometries, spiral profiles including sense of lead (clockwise, counter-clockwise) and material they are made of but also with different surface treatments.
- Low price of the twist drills with Morse taper shank assembled in such a way because the full-value drill with Morse taper shank can be quickly assembled by means of CZMK fixture and the straight shank drills which you already own.
- Severalfold lower costs for drill liquidation or disposal due to ending of its life and its subsequent reproduction because CZMK fixture remains and you replace only the straight shank drill which is severalfold cheaper in comparison with twist drill with Morse taper shank of the same diameterPodstatně vyšší přesnost a tuhost upnutí nástroje při dosažení velké upínací síly po celém obvodu válcové stopky vrtáku.

Very small dimensions of CZMK fixture enable to use it even on the place where very limited place for machining is.

The possibility of using the CZ002 and CZ004 drills even on the place where only the drills with Morse taper shank with standard geometry have been used so far.

The possibility of choosing the size of Morse taper for individual drill diameters according to own technical requirements and machinery and thus clamping even the drills with small diameters directly into the spindle cavity without using reduction sleeves

The possibility of setting repeatedly the same drill length even after it has been reground including the possibility of pre-adjusting and thus shortening adjusting times.